The SPLITMUX® Low-Cost HDMI Quad Screen Multiviewer allows you to simultaneously display real-time HDMI/DVI video from four different sources on a single monitor. It is capable of displaying the video sources in quad, PiP, or full screen mode. The audio/video output can be extended up to 250 feet away via a single CAT6/6a/7 cable.
· Quad, Picture in Picture, and Full Screen display modes.
· Independent video in to video out resolution.
· Supported resolutions:
o Input: HTDV resolutions to 1080p and computer resolutions to 1920x1200.
o Output: 1080p, 1080i, 720p, 1024x768, 1360x768.
· HDMI features supported:
o Inputs: 24-, 30-, and 36-bit xvYCC, sRGB, and YCbCr.
o Outputs: 24- and 30-bit sRGB.
o Four-channel non-mixing stereo with 16-, 20-, or 24-bit uncompressed PCM audio.
o Bandwidth up to 165 MHz.
o Inputs: 2.25 Gbps
o Output: 2.0625 Gbps
· Fluid, real-time video performance with 60 frames per second (fps) in all four quadrants.
· Switch audio independently of video from connected HDMI sources in Quad mode.
· Any DVI source or display can be connected by using the DVI-HD-xx-MM cable (not included).
o Use DVIA-HD-CNVTR-LC or DVI-HD-CNVTR DVI + Audio to HDMI Converters to pass and independently switch audio signals to the multiviewer.
· Control the multiviewer through front panel buttons, IR remote, or Graphical User Interface (GUI) via RS232.
o Bi-directional IR control from multiviewer and remote unit locations.
· Cascade multiviewers to display video from any number of video sources on one screen.
o Each unit in the cascade must be configured and controlled individually.
o Cascaded outputs can be extended using the remote unit as long as the combined total CAT6/6a/7 cable length between all levels of the cascade does not exceed 250 feet.
o Compatible with SPLITMUX-HD-4RT for cascade configurations.
· Adjust output video brightness, contrast, color, and sharpness.
· Supports simultaneous local and remote HDMI output.
o Features coax SPDIF audio outputs at the multiviewer and receiver.
· Built-in default EDID table.
o Supported output resolutions can be selected.
· ARC (Audio Return Channel) support at the receiver unit via coax SPDIF output for speakers.
o Turn ARC on to play audio from an HDTV with ARC support to the connected speakers.
o Turn ARC off to play audio from the multiviewer source to the connected speakers.
Note: This device does not support HDCP.